- Tip with different brush inserts for complete cleaning of surfaces
- Cleaning implant surfaces in cases of peri-implantitis
- Cleaning of crown stumps after temporary restorations
- Removing cement residue
- Low-fatigue cleaning
- Very clean surfaces
Sonobrushes for professional mechanical tooth cleaning. Oscillating brushes for gentle and effective plaque removal and cavity cleaning, fissure cleaning prior to sealing, cleaning of inlay cavities.
The problem
Some professional dental care products are too aggressive or almost ineffective. Some instruments cannot reach areas that are difficult to access.
The solution
A method for gentle, efficient coating removal using sound with a wide range of vibrating brushes:
- Small and large cones.
- Small and large planes.
- Small and large rollers.
Substance removal and surface roughness
The amount of substance removed and the roughness after treatment with SONICflex clean depend on the abrasiveness of the cleaning paste used.
The values determined correspond to the use of rotating brushes or rubber cups, or are lower. A comparison with a powder jet device showed that, in addition to a significantly higher loss of substance, the powder jet device resulted in significantly rougher tooth and restoration surfaces.
The “sonobrush” can be used as a supportive measure in professional mechanical tooth cleaning to remove plaque and discoloration and to polish teeth. Another area of application for the system is the preoperative cleaning of fissures, cavities, and crown stumps.
Special features
- Wide range with three different shapes in two sizes each
- Effective cleaning of narrow interdental spaces and complex cavities
- Gingiva is not damaged during use
- Delicate brush attachment provides good visibility even in the molar area
- Gentle on tooth and filling surfaces
- Water spray directly at the working area thanks to internal spray guide
- Tactile feel when guiding the brushes, even in hard-to-reach areas
- KaVo SONICflex clean brushes can be sterilized up to 10 times
SONICflex clean tips
SONICflex clean tips
- Treatment: plaque removal, fissure cleaning, cavity and crown stump cleaning
- Form: various attachments, disposable brushes
- Order number:
0.571.0401 (tip no. 48, suitable for SONICflex 2000 N / L, 2003 / L)
1.006.1982 (tip no. 48 A, suitable for SONICflex 2008 / L / LS)
0.571.0001 (suitable for SONICflex 2000 N / L, 2003 / L) - Brushes (suitable for both tip no. 48 and no. 48 A)
0.571.0402 (clean brush no. 1)
0.571.0412 (clean brush no. 2)
0.571.0422 (clean brush no. 3)
0.571.0432 (clean brush no. 4)
0.571.0472 (clean brush no. 5)
0.571.0482 (clean brush no. 6)
Inserting SONICflex tips
The working end to be used is screwed onto the SONICflex handpiece with the supplied torque wrench until you feel it snap into place. The working tip is now secured in the handpiece.
If the SONICflex handpiece is to remain on the treatment unit with the tip attached, we recommend leaving the supplied screw-in aid attached so that there is no risk of injury from the working tip.
